Drive Motor T200, T250, T300, T320 and 864

Details

New track drive motor for Bobcat 864, T200, T250, T300 and T320. This replaces or updates all former Bobcat hydraulic drive motor numbers 6690156, 66675586, 6674888, 7109868, 6684440, 6680250 and model motors R921810313 and 80687532 without joystick controls.

This new 6 bolt motor is of the "long nose" variety only. If you currently have an early model, "short nose" motor you will need to purchase new sprockets from Loader Parts Source, Inc. in order for this motor to work correctly on your machine.

You can tell which drive motor you have by measuring from the mounting flange to the sprocket. Short nosed motors have a distance of approximately 5 1/2 inches. Long nosed motors have a distance of approximately 7 inches, please see illustration for correct measuring points.

All Loader Parts Source, Inc drive motors are completely leak tested and then run on a test bench before being prepared for shipping.

Warranty Information:

Loader Parts Source, Inc carries the strongest warranty available today for track drive motors, six (6) months or 1,000 hours! Our warranty does carry a few stipulations and when followed you can expect a long, strong work life with your new Loader Parts Source, Inc. drive motor.

Before installation of your motor replace all standard filters on machine and clean out completely the copper filters on the case drain lines from your motors. (both even if you are changing only one motor) Replace old oil and blow out your hydraulic lines. The gear oil should be drained and replaced from the hub housing end every 200 hours. We use a high grade synthetic gear lube in all our housing ends and yours will be shipped full to you for the original install. A warranty card (supplied with your motor) should be mailed to Loader Parts Source, Inc. upon installation. If not or mailed incomplete it may and most likely will void your warranty.) A complete and detailed warranty page will be shipped with your motor. (warranty stated here is effective as of 5 pm on May 15, 2009

*Since drive motors are installed new by the OEM in pairs. Loader Parts Source, Inc. always recommends changing both drive motors as they have been exposed to the same wear and tear. This could save future down time and expense.*