Search results for: 'scat trak 1650d skid steer hydraulic drive motor'

See Details for More Information

See details for more information

Shaft: 13 Splined Teeth, 1.75'' Diameter

Shaft Diameter: 1½, 17 splined teeth

3 Pins are needed per Rotating Group.

Shaft: 17 Spline

• Length: 10 3/4 Inches (273.1 MM)
• Spin-on Filter for the Main Hydraulic System.

            *without High Flow

            **with High Flow

See details for more information.

See Details for More Information

1 inch Shaft,  15T Splined, 1.5" Extension, 26T on Back End

See details for more information.

See details for more information about the Skid Steer Loader models this OEM fits

See details for more information about the Skid Steer Loader models this OEM fits

See Details for More Information

*Since drive motors are installed new by the OEM in pairs. Loader Parts Source, Inc. always recommends changing both drive motors as they have been exposed to the same wear and tear. This could save future down time and expense.

Shaft Diameter: 1¾, 13 splined teeth

Output Shaft 1.5" Diameter, 17 T-External, 12 Internal Splines 

Shaft End Seal Kit is OEM 8032419

**NOTE When this machine is used extensively in an application where there is load on only the front or rear axle at high speed (such as manure scraping), there is a problem with these bearings going out. Since the preload is not adjustable, the assembly needs to be replaced.

See Details for More Information

See details for more information about this Bearing and Seal Kit

See details for more information...

*Re-manufactured items do not include fittings unless required for conversions.  Drive pump adapter is not included. Please keep your fittings and drive adapter.* 

See Details for Important Information regarding core returns and what is included with your Re-manufactured Engine.

*Re-manufactured items do not include fittings unless required for conversions. Please keep your fittings*

See Details for Important Information regarding core returns and what is included with your Re-manufactured Engine.

*Re-manufactured items do not include fittings unless required for conversions. Please keep your fittings*